- Ball-end cutter able to undercut (3 replies)
- Cutting cabinets with a 1/4 or 5mm bit (20 replies)
- Raster 3D Strategy - Across wood grain, or not? (3 replies)
- How would you machine this? (7 replies)
- Is shopbot the way to go? (7 replies)
- Eliminate ridges on edge of parts (0 replies)
- Free: Bits, Feeds and Speeds Chart (18 replies)
- OAK (4 replies)
- RADIUS HELP NEEDED (5 replies)
- Aspire Toolpathing 'holes' question (7 replies)
- What I have learned today (4 replies)
- Multiple parts on a single sheet of material (1 replies)
- Edge roundover on plywood. (5 replies)
- Is Trupan Bleeder Board Available in Canada? (13 replies)
- Cuting 3d vector? (9 replies)
- Any way to speed up cutting? (13 replies)