Vs parameter warning

[magic]

I can't figure out where the problem is but when I press "go" a warning window appears with the following:

Paramater Value Below Normal For VS - Setting to lower limit (.05)!

Been monkeying around with the settings for 25 minutes and I give. How do I fix this?

Thanks

[thewoodcrafter]

That is an error message I have gotten from V-Carve Pro when I had the tool feed speed set wrong.
It is lower than the machine will do.
This happens when MM and inches are mixed.
Open the file in the SB editor and look to see what MS is set to.

[magic]

Yes First time I used that tool.

I normally run things at I per S and the tool was set at I per M - so when I plugged my usual numbers in, they were wrong for the speed.

Here's what I'm workin on, The painted version becomes carved

Thanks.
9067

[thewoodcrafter]

Thoughs look really cool.