geneb
12-18-2007, 12:06 AM
I've done a video that shows my 'bot cutting a bit of aluminum for my simulator project.
Before you watch the video, understand that this is NOT how to safely operate a ShopBot! You'll see at least two glaring operation errors, including forgetting to restart the spindle after stopping it to make an adjustment and putting my tender fingers WAY too close to the cutter in an attempt to place painters tape over newly opened holes to retain vac hold.
This video is nearly as much of a How Not To as it is a How To.
Enjoy!
http://www.youtube.com/watch?v=ccCSD9LjqPI
g.
Before you watch the video, understand that this is NOT how to safely operate a ShopBot! You'll see at least two glaring operation errors, including forgetting to restart the spindle after stopping it to make an adjustment and putting my tender fingers WAY too close to the cutter in an attempt to place painters tape over newly opened holes to retain vac hold.
This video is nearly as much of a How Not To as it is a How To.
Enjoy!
http://www.youtube.com/watch?v=ccCSD9LjqPI
g.