Drill fan replacement

[coach]

I purchased a replacement fan for my 2.2 spindle. Although I haven't replaced it because it seems to be running fine, but once in a while it shuts off for 3 or 4 minutes then works fine for a few days.
Is the fan actually pushing the heat out of the spindle?

I am looking for documentation for replacing the fan. I don't want to take it apart and spend a full day trying to figure out what I need to complete the process.

Any ideas where I can find these instructions?
Also,,, big thanks to tech support who phoned me over the weekend.
This is not the first time they have helped me on a Saturday and or Sunday.
Thanks guys.

[cookie]

I just replaced my fan. I removed the screws that hold the fan motor housing not the guard. I just cut the wires and removed the bolts that hold the fan and reinstalled the fan and used wire nuts to connect the wires. Less than an hour the first time. Its not hard. Good luck Bruce

[coach]

Thank you Bruce. when can you do mine.....lol
I appreciate the input.

[cookie]

Do you pay for travel expenses? I do need a vacation. I'm tired of moving snow here in sw MN.