zeroing routine for x and y

[wmcghee]

I updated my control software yesterday and for some reason I lost the xyzero.sbt program. Now when I view it its only 3 lines long. Hoping someone could send me theirs. Mine is a PRTalpha with proxy switches. I attempted to program it myself but I didn't know where to even start. I really appreciate any help.

[dana_swift]

The installer installs the files in the current SB configuration, so before you replace anything, be sure you are not creating a mess. If there was an error and you just need a working XYZero, here is what I use.

I have attached XYZeroFixed.sbc, it allows X&Y to work in either the factory configuration, or swapped.

Extract the file from the zip file, adjust the offset value to move from the prox switch location to the table 0,0 location and you should be good to go.

Hope that helps-

D

[wmcghee]

Thanks Dana, that will work. I also downloaded the control software again and it was there this time. I don't know why I didn't think of downloading it again before I asked for it.