restart a cut from a set conman line

[matney_models]

Can you restart a cut from a set conman line, IE 1630

[erik_f]

Yes you can...just make sure that you are very close to above where that line starts. The SB will not start from where ever you have it, jog over and then plunge. What will happen is say your line is at 12,12 and you had to rezero your x and y...if the depth of cut at 12,12 is -.75" it will lower the z over the distance of the jog to your start line...this will leave you with a gash is your piece.

[kfitz]

What is a conman line?

[dubliner]

" I promise, I'll have it back to you by Friday" is one I've heard.

[garyb]

I've always loved "the checks in the mail" :D

[dubliner]

That was from when Gary ordered a bride from Prague :-)

[garyb]

What was that Neville "how do you spell castration" :D

sorry didn't mean to hi-jack the thread, would that be low-jack if you're under 5' ?