plemon
06-01-2010, 10:15 PM
Hey All,
I am trying to nut out the issue with my stepper motors and spindle not firing up when I press the reset button. While I wait for the time difference (I'm in Australia) I am trying to nut it out. I have noticed a little LCD in the control box that cycles through 1, 2, 3 when I press the reset button and then restarts. Is this related to the 4 stepper motor outputs and it is having an issue? Should it go 1, 2, 3, 4? When it was working I didn't observe what the LCD was doing so I'm not sure if its giving me an indication of anything wrong or not.
Phil:confused:
I am trying to nut out the issue with my stepper motors and spindle not firing up when I press the reset button. While I wait for the time difference (I'm in Australia) I am trying to nut it out. I have noticed a little LCD in the control box that cycles through 1, 2, 3 when I press the reset button and then restarts. Is this related to the 4 stepper motor outputs and it is having an issue? Should it go 1, 2, 3, 4? When it was working I didn't observe what the LCD was doing so I'm not sure if its giving me an indication of anything wrong or not.
Phil:confused: