Pocket cutting Shaker doors

[dubliner]

I was thinking of using 1/4 in to start whicch would cut to 1/4 depth easily enough, and then using the Onsrud 1.25 surfacing bit, but it just occurred to me that a1/4 in cut with that bit may be too much. I need to pocket cut doors that will fit on 5 sheets of mdf, so thats probably about 2 sheets worth of pockets, what do you think? Dubliner

[Gary Campbell]

Nev...
Want the best? Look here: http://www.toolstoday.com/p-5714-insert-spoilboard-surfacing-rabbeting-router-bit-with-scorer-2-2-design.aspx