Toolchanger PP with Aspire

[dlcw]

I am about to embark on using the "ShopBot_alpha_Arc_inch_Toolchange_control" PP file.

I'm looking for feedback from folks who have taken the plunge with this PP. According to Ryan at Shopbot, it uses the same C6,C7 and C9 that are used for SBLink and these are all tuned perfectly for my machine. TIA.

[Gary Campbell]

Don...
I have just emailed you a copy of my MTC Vectric post. It has the "zshift" material offset enabled like we use with the SB Link, disable this feature should you care not to use it.

I just looked at the ones "shipping" with 3.6.18. The OEM "arc inch toolchange" needs some changes to operate properly, but it looks like the "ShopBot_TC_inch" looks good to go

[dlcw]

Thanks Gary! I will call you today.