"SHIFT" > or < not working to change cutting speed

[toddho]

I have read in two different places in this forum that, if while cutting, you can use SHIFT > to increase the cutting speed. This doesn't seem to be working. Is there something else that I missed?

Thanks
Todd

[knight_toolworks]

Well I have not tried it for awhile. but it does screw with ramping. so the machine can become jerky. it's better to hit enter then choose command and type ms

[toddho]

Never mind! I was using the "SHIFT" right Arrow key Not the ">" (above the period). I hate when I figure it out right after I post!

Todd

[chiloquinruss]

"I hate when I figure it out right after I post!" what I hate is when I figured it out yesterday but I can't remember how to do it today! :) Russ

[gerryv]

I here ya Russ... By the way, what was that you said again???

[ken_rychlik]

What I want to know is why the ramping of the motors goes out the window when you do change the speed this way ???

I never do it because of this happening.