View Full Version : MO command
Mike Windsor
02-10-2011, 11:03 AM
Hi I am finally using my 4G board and everything seems to be working OK so far . --I cant seem to get the MO command to work though . ---Has this been disabled ? ---I used to use it all the time to square my gantry . --now I have to turn off the control box .
srwtlc
02-10-2011, 08:11 PM
Mike, I'm pretty sure it's obsolete now with the 4G and Alpha. Something that they need to clean up from the menu.
I'm experiencing the same problem. Just upgraded my board to PRT with Geko Drives and installed the latest software. MO command does not work. Is this something I will have to live with, or is there a fix out there somewhere?
jerry_stanek
02-13-2011, 04:55 PM
If you check the command list MO will not work on a PRS or PRT alpha your g4 upgrade made your machine act like a PRS.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.