stop the ramping question

[steelcnccutter]

still new and cutting plexiglass. I am cutting with a 5/64 endmill in plexi and when cutting on a part with lots of detail causes the machine to slow down in the corners slower than I programmed (sure it is a ramping thing). the non detailed parts seem to cut ok but the detailed ones melt and reweld baddly.
any help on telling the machine to limit the slowdown? thanks steveO

[gc3]

http://www.shopbotblog.com/index.php/2008/03/a-ramping-the-vr-command-and-how-to-tune-your-tool-for-maximum-performance/

The sharper a corner the more the tool will slow down
scroll down to this section...

[steelcnccutter]

Gene the information was right on the spot. as always your willingness to help and share your knowledge is refreshing. I am still looking to the day I can meet you. a great thanks for you help. steveO