Help with file

[sawkerf]

I was aked to cut some letters for a local sign shop but I can't get the file to open. I use Artcam Insignia and I'm just not familiar with anything other than what I use for cabinets. Can anyone help me convert the file to a format I can use? I tried to upload it but I get a "file is too big error". It's 358.1 KB. I can email it to whomever is willing and able:) Any help would be much appreciated..............Oh, and what do you cut this aluminum and plastic sandwich stuff with :confused: Thanks! Kip

[zeykr]

What format is the file in?

I cut dibond with o-flute or 1/8 upcut (good face down). A pressure-foot is a BIG help.

[jerry_stanek]

I cut with a lot of diebond

[sawkerf]

Sorry, I thought I had posted the file ext. It's an EPS. Thanks

[billp]

Kip,
Have you tried to "import" the .EPS rather than "opening" it yet? It should work in Insignia.....

[sawkerf]

I did try to import but it said the extension was not supported, which doesn't make sense because that's what I use to import vector Art. But like I said, I'm just a cabinet guy, not much experience with much else.

[garyb]

Kip
If you want to email it to me I will convert it and send it back. It should be as Bill stated just go >vectors>import.
Do you know what it was produced in?
what version of Insignia are you using?
Gary

[sawkerf]

thanks gary, you should have mail