Bolt head DXF

[gundog]

Anyone want some bolt head DXF files I use these often for mechanical parts I make I drew them in Aspire and I use them by pocketing or inside profile to get the inside completely removed an .125" cutter is necessary for the inside profile the 7/16" head you can just do an inside profile with the 1/8" cutter then drill a center 1/4" hole to fit a 1/4" bolt or nut.

Mike

I noticed I had the 7/16 & 1/2 reversed so I fixed it if anyone saved the file before this edit delete it and save it again it is correct now.

[COBOB]

Thanks for that. I will use them. Thanks for sharing.

Bob