bluecollar
10-21-2011, 10:20 PM
After a cross country move (Texas to Raleigh NC of all places), I'm getting myself reacquainted with my Shopbot. My design computer (not SB controller) crashed and I re-loaded and installed PartWorks 2.5. It seems now like the SB is 90' out of phase with my output. If I write it out using PW 2.0, and select ShopBot (arcs)(inch).sbp format I'm good. But with PW2.5, my only english unit output option is ShopBot (inch).sbp.
Any inputs on what setting/configuration I'm missing?
Steve
Any inputs on what setting/configuration I'm missing?
Steve