richard_saylor
12-11-2011, 05:51 PM
I have a PRS Standard BT32 and am using Partworks 2.505.
I'm cutting all the way through 2" pieces, so I have little Z travel left above the piece I'm cutting. I start with the tool .5" above the surface of the piece, but the post processor writes in a JZ .8 move which is beyond the machine's limits. I've been going into each file and eliminating this move. Is there a way to keep the post processor from writing this in? The Z1 is set at .2 in my material setup. I'm using the Shopbot (inch) post processor.
I'm cutting all the way through 2" pieces, so I have little Z travel left above the piece I'm cutting. I start with the tool .5" above the surface of the piece, but the post processor writes in a JZ .8 move which is beyond the machine's limits. I've been going into each file and eliminating this move. Is there a way to keep the post processor from writing this in? The Z1 is set at .2 in my material setup. I'm using the Shopbot (inch) post processor.