Curve fit vector

[khaos]

Is there a similar methode in Aspire to PartWorks "Curve fit vector"? I was reading another post and I believe that I have some files that could be greatly improved by converting line segments to actual curves. I imagine that cut file size would be reduced and possible decrease time parsing cut commands. Maybe improve cut qualty ...

I am not at my design computer so if it obvious please forgive me. :)

[tmerrill]

Both Aspire and Pwks/VCP have the same command available. You can convert to arcs or Beziers - I normally do arcs.

Tim

[khaos]

Tanx! I really appreciate this forum. You people rock.