simple z zero table setup

[knight_toolworks]

This is a simple z zero for zeroing off the table surface. the simple custom file just to the location zero's then asks for the thickness and zero's again.
I use a straightedge to get it flush with the table. with the two knurled knobs it is fast and easy to adjust after flattening the spoilboard.
I just used some 5/16" brass all thread and knurled knobs. a piece of aluminum threaded for the rod and the grounding wire is screwed to it.
http://dl.dropbox.com/u/1939753/Custom8.zip
http://i154.photobucket.com/albums/s266/knighttoolworks/posting/1E4DFEDC.jpg

[bleeth]

Nice and clean Steve.;)

[knight_toolworks]

a lot better then my first one
http://i154.photobucket.com/albums/s266/knighttoolworks/posting/F4AAFBE2.jpg

[geneb]

I should try that on mine - I'd use a big magnet set to hold it to the 'bot though.

Thanks for the idea Steve! :)

g.