question..

[Ajcoholic]

When you are cutting parts out of plywood, with tabs and slots that are to fit together -

if you want to incorporate the small "notch" made by the router bit in the inside corners (to allow a square tab to enter the slot made by a round cutter) do you have to draw in each one by hand or is there a feature/function of the software that does it automatically, if chosen?

Thanks,
AJC

[tmerrill]

Look at the Dog-bone option in the Fillet tool. Good explanation on how to use is in the Help Contents.

Tim

[Ajcoholic]

Thanks! That was easier than I expected...

AJC