360 is not 360 ?

[lee_pruitt]

I just received my indexer and a new Gecko 203v driver. I installed the unit and nothing happened. I swapped out another driver a 202 from inside my control box - It worked just fine.
Except I type MB 360 and it rotates about 320 degrees. What am I doing wrong ? Or is this because Shotbot set the indexer up using a 203 driver ?

Anyone have any ideas.

Unfortunately no instructions were shipped with the indexer. So I am using my original shopbot manual.

Thanks

[myxpykalix]

It sounds like your values are set incorrectly. I tried to open my laptop to see what my values were but it gives me error messages because i'm not hooked up to the bot "error 13 type mismatch" and just kills the pgm and won't let me continue in preview mode so i can't give you any more specific info.

[cip]

My indexer value is set at 13.8889

Type VU at the shopbot console and check the B unit value.

Hope this helps