latest project

[cowboy1296]

i learn more with each cutting. this is the latest

[Ajcoholic]

What type of bit did you use for that? How did it take to carve?

Looks very nice!

Andrew

[cowboy1296]

the finish tool path was done with an 1/8 of an inch precise tappered bit. the speed was set at 3 inch per second and 7 percent stepover. it took 4 hour and 30 minutes. done in alder, very little fuzzies if any. i forget how long the roughing took... i am sure i did it with a quarter inch bit.

i did a roundover on the profile.

[cowboy1296]

ps thanks, forgot to acknowledge your comment.

[danhamm]

Way to go Rick, nice....