daski
04-23-2012, 06:27 PM
on our PRT, When we hit the space bar to stop the machine or by accident, then "Resume" the travel speed is super slow until it gets to the end of the vector it's on then the speed returns to normal. Can some of you perform this test to see if you get the same results please.
on our PRS Alpha if we hit the end X proximity switch, "Quit" then do a JH the machine moves very slowly but also the x and y measurements are out by a factor of 5 or so. The gantry will move about 24" but the screen says it moved 120", same issue with the Y axis.
Anyone else noticed the same sort of problems? I've talked to Shopbot, and I'd like to know if others have the same issue. Please test and let me know.
on our PRS Alpha if we hit the end X proximity switch, "Quit" then do a JH the machine moves very slowly but also the x and y measurements are out by a factor of 5 or so. The gantry will move about 24" but the screen says it moved 120", same issue with the Y axis.
Anyone else noticed the same sort of problems? I've talked to Shopbot, and I'd like to know if others have the same issue. Please test and let me know.