kubotaman
04-25-2012, 07:49 PM
Okay so I lost communication with my computer but that is not why I am asking this question. When I lost communication, I wrote down which line was displayed and where the X and Y axis where. I then go to the file go-to command and enter the line I want to start at. I also move to the X and Y coordinates I was stopped at. Of course I had earlier done a C3 command and re-zeroed the axis's. When I set the Re-Start line to the line I want to start at, all I get is a pop-up that says "Attempt to start past end of file". I then go to the editor of files and find the line that I want to start at has different coordinates that the one's I wrote down! Can someone explain what has happened? No matter what I do the same pop-up will appear when trying to re-start cutting.