Vacuum Pump 1100W Centrifugale Vane 24"x36" CNC Router Mill Hold-down

[kevin]

Vacuum Pump 1100W Centrifugale Vane 24"x36" CNC Router Mill Hold-down

I usally don.t post link .But there is a lot a talk about hold down

http://www.ebay.com/itm/Vacuum-Pump-1100W-Centrifugale-Vane-24-x36-CNC-Router-Mill-Hold-down-/160800877915?pt=LH_DefaultDomain_2&hash=item25707aad5b

http://www.motiontek.ca/index.html

[michael_schwartz]

The specs are a little bit vague but it looks like the performance would be similar to a fein. If I did the conversions right, it looks like you would get about 7.2" HG max, with about 100 CFM.

With my pair of Lighthouse 6765-13 motors, I get I get about 10-10.5" HG with the zone valves closed and about 8.5-9 with a sheet on the table.
The low end when cutting thru parts, is about 7-7.5" HG. When cutting a lot of small parts with a trashed spoil board I don't think I have seen my gauge drop below 6.5" Both motors cost just under $250.00

[kevin]

Micheal

The big difference its an induction moter .Also it uses less amps

I know its not a Repulic but a China motor