reset tool stop

[dave swanyek]

Blinking red light. Try to move tool it tells me to reset tool stop button?? Prsstandard help please

[myxpykalix]

do you have an EMERGENCY STOP button? Big red button,
if so you have to twist it slightly to allow the button to be released in order to gain control back of the program.

You will also have to go push the reset button on the control box

[dave swanyek]

I have the prsstandard no fancy e stop pr wonderful reset button. Getting very frustrated.bow has button and will not turn no rest on control box

[myxpykalix]

i have a prt alpha that has a E stop big button on a wire and 2 buttons on the box one for reset of the controllers and another to start my router.

There HAS to be a reset button somewhere externally on your control box somewhere. Do you see a red button anywhere? Can you post a picture of your box? I'm not familiar with your model.:confused:

[jerry_stanek]

On my PRS Standard I have my E stop button at the end of the table. check to see if yours is connected. Also you may be able to go into your values and change the E stop from normally closed to normally open to get you going.

[dave swanyek]

I did change the values to normal open got me going there. but now no power thru the contactor to the router AHHHH

[jerry_stanek]

Do a ur and see if resetting your values will clear up your problems

[garyc]

Dave....
From the SB3 console type the command [U][R] and choose default settings. navigate to the PRs folder, then to standard and select the settings for your size machine.

[dave swanyek]

I will do that tomorrow I just switched the no/nc for today.