Log in

View Full Version : arched raised panels


randydimmette
10-18-2012, 05:11 PM
trying to make and arch raised panel to match some raised panel doors
trying to use 2 rail sweep in aspire with no luck
feinddj
10-18-2012, 05:56 PM
Should be able to to that, what, exactly, is the issue?
Screen shots are a good way.
randydimmette
10-18-2012, 06:24 PM
the outside line is the overall size
the inside line is the cut out where the panel will go
and the outer line is the profile of his bit
feinddj
10-18-2012, 08:20 PM
Randy,

Go to node edit mode and make sure that the outer and inner lines start in the same corner.

Make sure that CONNECT RAIL NODES is checked

You may have to flip the direction of one of the rails.

You may have to flip the direction of your profile.

This should get you most of the way there.

D