dstacey
11-10-2012, 01:23 PM
Hay Guys I need some help please.
I have a PRS Alpha with an Air Dril but It's been some time since I used my drill, but I have used it in the past and it has worked fine.
Today i zeroed it and tried to run it but I keep getting a message that says, "file not found c:\sbparts\custom\custom8.sbc" (there is no custom8 file there, several other custom files but not 8)
I built a test file that just has one hole an inch from the corner and I made 2 toolpath one for the spindle and one for the drill. if I cut the one with the spindle it cuts a small hole just where it should, but when I run the drill path it moves away from the board rather toward the 1" mark and then I get the message. I used the shopbot airdrill processor to build the air drill path.
Any idea why it's looking for this file, and why it's not there?
Thanks so much!
Dave
I have a PRS Alpha with an Air Dril but It's been some time since I used my drill, but I have used it in the past and it has worked fine.
Today i zeroed it and tried to run it but I keep getting a message that says, "file not found c:\sbparts\custom\custom8.sbc" (there is no custom8 file there, several other custom files but not 8)
I built a test file that just has one hole an inch from the corner and I made 2 toolpath one for the spindle and one for the drill. if I cut the one with the spindle it cuts a small hole just where it should, but when I run the drill path it moves away from the board rather toward the 1" mark and then I get the message. I used the shopbot airdrill processor to build the air drill path.
Any idea why it's looking for this file, and why it's not there?
Thanks so much!
Dave