Spindle Speed window doesnt come up after upgrade...

[sagreen]

Today I upgraded my Shopbot software to the most recent version available. After I did the upgrade my spindle speed window wont come up anymore.. I tried to use the T R command from the main menu, and the speed window will still not come up.

Anyone have ideas?

Thanks!
Scott...

http://www.rmgvideos.com

[jerry_stanek]

Try the UR command I had that problem and it was holding the wrong INI

[srwtlc]

Scott,

This has happened before and since you can't bring up the fill-in sheet, the only way I found was to set it in windows registry.

If you're comfortable with nosing around in Windows Registry (start run regedit.exe), you can go to...

HKEY_CURRENT_USER\Software\VB and VBA Program Settings\ShopBot\Virtual Tools\Spindle Control\Main

Once there, double click on "port no." and change the value to the port that it is supposed to be. You should then be able to start the program and then click on RPM to bring up the fill-in sheet to change any other value.

[jerry_stanek]

Also make sure that you have the correct VFD in the fill in sheet