How to change my Zero corner

[LesLinton]

Ok, the PRT 96 has been in mothballs for a few years but I now have it all set up with the new controller mounted and wired. Prox switches are installed, everything seems to be working, but I have always had 0,0 as I face the end of the machine as my "lower right" corner.

If I make that corner 0,0 and do M2 2,2 it moves left 2 and comes at me till it hits the prox switch.

What am I doing wrong?

Les

[jerry_stanek]

Try the unit value settings you can change the direction by putting a negative in front of the unit value or if it has a negative value remove the hash mark

[LesLinton]

Thanks Jerry, I knew it was simple. Flattening the table as we speak.

Les