Fonts

[gary_k]

I have ArtCam Pro 9 and I am working on a new project for a customer I have worked with before. I tried to create new verbage for this new sign and could not find the same font as I used before on my new computer so I opened my old computer and found it under Part Wizard.

Will it cause any issues if I load Part Wizard from my installation disk on my new computer that operates with Windows 7 (the disk does not list Windows 7)? I know you are supposed to load Part Wizard before the control software - will it be a problem to try to load after the control software or are there advantages to having Part Wizard other than the couple of fonts I have found? Is it even worth the effort?

Thanks,
Gary

[Rick W]

Gary,

Why don't you go into the control pannel of your old computer and copy the font??

Rik

[jerry_stanek]

I run partwizard on my windows7 64 bit laptop so you could but that would not mean that the font you need will be there. It could have been a font that another program loaded. Just go to fonts and copy and past in the fonts file.

[gary_k]

sounds good - thanks!