Maybe its time to go full 3D?

[Rob Gunn]

I think I am almost to the point of going full 3D with mu ShopBot. The past 2 years I have been using V-carve and its done very well. Now I want to go full Aspire. Before I purchase a new license I am just wondering if there are any copies out there that someone would consider selling? Its my understanding that selling a used license is doable but with a additional $50 transfer? Is this correct?:confused:

[jerry_stanek]

You can upgrade your Vcarve pro to Aspire

[kubotaman]

Rob, I can tell you along with a lot of other fellas that you can't go wrong with Aspire!!