View Full Version : About to cut my 1st Cabinet

08-03-2013, 04:56 PM
I have the tool paths created, and they look all righ to me in SB-Preview. But, I would just like for some of the knowledgeable people on here to take a look at the tool path.

My biggest concern is that it will not stop and let me change bits. As I have a 1/8th bit drilling the shelf and hinge holes, and a 1/4 inch bit cutting the rest.

Please take a look at the attached file and let me know if it is indeed going to work.


08-03-2013, 05:19 PM
A quick note David:
Shelf pins typically come in either 5mm or 1/4" size. I don't personally know of 1/8" size. For hinges, if you are going to screw the plates in then 1/8" would be a little big for the typical 5/8 x #6 hinge screws. If you are just using the 1/8 bit as a location marker that is OK. For the Euro system screws then they are also made to screw into a 5mm hole. 5mm bits are available from Centurian. I've been using them for years.
I don't have time to look over your file right now, but will do so in the morning if someone else hasn't.

08-03-2013, 05:20 PM
the attached file appears to just be a notepad text doc

08-03-2013, 08:20 PM
curious, Never the less the cut was a total failure. Dadoes were all wrong. 50.00 sheet of plywood, chock one up to testing


08-03-2013, 08:22 PM
This is the file generated by CPP.

08-03-2013, 08:48 PM
Check your PM.