Material Issues

[GlenP]

Hi All. I have a new panel lifting device on my table saw and it works great so I mounted one to the end of the bot. I use 7/8 mdf and it is heavier than.....well it is heavy. This "Leg Up" device works great. I also use one of these sheet carriers with it and the combination of the 2 have made things easier on me in the shop. I now pull sheet out of rack, place in carrier, wheel over to the cnc and use the leg up to lift onto the table. I was looking at putting in a vac lift and may still do it, but til then these 2 things have helped me big time.

http://www.youtube.com/watch?v=Zdo90fJ4KLk
http://www.youtube.com/watch?v=bS0GL31fRF8

I bought mine from Richelieu here in Canada.

Cheers,
Glen

[adrianm]

Can't quite get my head around where that would mount to let you lift the sheet onto the 'bot.

I'm terrible with descriptions so any chance of a picture? I think it could be very useful for me but I'm not sure if I've got the room.