mikelush
01-03-2014, 03:18 AM
Hi all,
I'm engraving four maple decorative posts with a celtic weave for my fireplace (each almost 4 feet long). What I was wondering is what people are using for a final sanding and then finish. I want to use my dremel with sanding discs but I'm afraid they will scratch, then finish with danish oil/foam brush? Biggest project I've attempted so any advice would be appreciated. Thanks.
I've attached a pic of one post almost finished with the rough cut.
I'm engraving four maple decorative posts with a celtic weave for my fireplace (each almost 4 feet long). What I was wondering is what people are using for a final sanding and then finish. I want to use my dremel with sanding discs but I'm afraid they will scratch, then finish with danish oil/foam brush? Biggest project I've attempted so any advice would be appreciated. Thanks.
I've attached a pic of one post almost finished with the rough cut.