bryan
03-19-2014, 04:46 PM
https://www.dropbox.com/sh/87n37ecb3tsvyf5/HTqTSkZcLF (https://www.dropbox.com/sh/87n37ecb3tsvyf5/HTqTSkZcLF)
The above link is to a dropbox folder that has a project that I’m finishing up this week. Showing several step by step photos at different stages of the project thumbnail attached.
White Oak base 27” x 24” x 1 1/8”
Inlay is Paudauk approx. 21” diameter
The letters and figures were v carved with 60 v bit cutter.
V carving painted with black gloss enamel
Finish is gloss lacquer
Looking for any feedback on how I approached this project to save time or make it easier, as this hobby of mine is getting closer to being a full time job, and that I do not mind. :)
The above link is to a dropbox folder that has a project that I’m finishing up this week. Showing several step by step photos at different stages of the project thumbnail attached.
White Oak base 27” x 24” x 1 1/8”
Inlay is Paudauk approx. 21” diameter
The letters and figures were v carved with 60 v bit cutter.
V carving painted with black gloss enamel
Finish is gloss lacquer
Looking for any feedback on how I approached this project to save time or make it easier, as this hobby of mine is getting closer to being a full time job, and that I do not mind. :)