Trying to contact Barry Rimmer

[norm]

I'm having problems with his XYZ_Zero routine and would like to contact him for some help. I've send two emails to his address on his website, but they've come back as undeliverable. I've also sent him a private message on this site, however, he hasn't been active since 2011 so don't know if he even checks here very often. If anyone knows Barry, would you let him know there is a PM here or please ask him to contact me. Thank you for your help contacting Barry.

Norm
Appling, GA

[myxpykalix]

If you are not having luck contacting him, you may want to post what you have and explain your problem and maybe someone here can help you...:confused:

[norm]

Thanks Jack. I'll give him a little time before I come here.

Norm

[norm]

Cancel the search for Mr Rimmer. After a couple days of frustration, I finally figured out where I needed to add a couple lines of code. The XYZ zero program is now acting as it should! Thanks everyone.

Norm

[boxbond]

Hi Norman

I have been having a problem with the same program.
Could you let me know what were the changes you did to keep the axis moving. The routine just does not want to touch the opposite side of the metal ring.