jkaras
04-01-2014, 05:28 PM
Hello-
I model my 3D object in Microstation v8i. I export it into an .stl file type. It has worked many times in the past, but for some reason the geometry, which is slightly more complex this time, is not being interpreted thoroughly into the Partworks 3D program. Is there an issue with using an STL? It is processing most of the detail correctly, but sometimes it simply shows the toolpath going completely through my object. Any advice?
Thank you!
I model my 3D object in Microstation v8i. I export it into an .stl file type. It has worked many times in the past, but for some reason the geometry, which is slightly more complex this time, is not being interpreted thoroughly into the Partworks 3D program. Is there an issue with using an STL? It is processing most of the detail correctly, but sometimes it simply shows the toolpath going completely through my object. Any advice?
Thank you!