marcrunner
04-26-2014, 11:09 PM
Hello Everyone!
Was asked to do this ring box for a gentleman proposing to his fiancee. Was alot of fun, but was difficult to keep all of the edges crisp, so they mated well. This was a customer supplied stl file, I just had to adjust the interior pockets from 3d curves to crisp 90's. When cutting each half, i did the perimeter "Ring" with a ball nose bit, using the project onto 3d model function in Aspire. I wonder if I could have used an end mill to route this ring more cleanly? Thanks, Marc
Was asked to do this ring box for a gentleman proposing to his fiancee. Was alot of fun, but was difficult to keep all of the edges crisp, so they mated well. This was a customer supplied stl file, I just had to adjust the interior pockets from 3d curves to crisp 90's. When cutting each half, i did the perimeter "Ring" with a ball nose bit, using the project onto 3d model function in Aspire. I wonder if I could have used an end mill to route this ring more cleanly? Thanks, Marc