Worth watching just for the automatic gasket CNC

[Bob Eustace]

Its rather incredible how this craftsman can assemble such a complex piece of kit in just 11 minutes - and hes not following a manual!

http://youtu.be/Xuc8sVERy6Q

[scottp55]

Thanks Bob, I was wondering where the CNC came in. Fascinating and like that last little "touch":)

[Bob Eustace]

Next we will no doubt see McDonalds putting their logo on the top of their coffees using a CNC! Seriously though it is amazing how far we have progressed in just 50 years and all the technology that has gone into that motor and the thing turns by hand first pop! I could never remember all the steps that technie has to follow and I only saw him look at one bit of paper for a second. Amazing!

[johnh]

Really cool. Assembly under perfect conditions. He didn't seem too concern about the rings spinning. Ive always wondered if the whole "clocking the rings" thing really helps anything at all beyond the first few minutes the engine runs.