stepper motor help

[lutchman]

hi guys,
i came into the shop this morning only to find that our prt alpha stepper motors are running intermittently, can anyone help? i uploaded a vid with this message but i have no idea where it was uploaded to :confused:....i tried to zero x and y axis, and i keep getting a jerking motion, it runs and stops for a half second and runs again and stops, etc. this happens with stepper motors on all axis? any suggestions?

[lutchman]

https://www.youtube.com/watch?v=ptkiV8wWlSQ&feature=youtu.be i uploaded to youtube, if anyone would like to see what is happening.

[paul_z]

I'd try a "UR" which will reload the ramp values.

Paul Z

[Brady Watson]

After you fix that, order a set of pinions for your tool & replace them - those are beyond shot. When you install them, clean and grease the rack to make them last. Your cut quality and overall machine smoothness will be increased many times.

-B