Mtc

[jerry_stanek]

I was looking at the Shopbot support and saw the video of the MTC and was looking for the pp for the tool change in my Aspire drop down does not have the Shopbot(inch)(toolchange)(w/speedcontrol). How do I get this post.

[srwtlc]

Jerry,

Look in your C:\SbParts\VCarvePro_forShopBotPosts folder and you can copy/paste the ShopBot_TC_inch.pp from there.

[adrianm]

The latest ShopBot Post Processors are installed under the C:\sbparts folder with the control software in the PartWorksPost or VCarvePro_forShopBotPosts folders. You can move them from there to the Aspire PP folder.

However you should have the "Shopbot(inch)(Toolchange)w/speed(*.sbp)" post or similar by default in Aspire.

[jerry_stanek]

I looked at the pp folder and it was there but not showing in my Aspire. I was wondering if it was because I still am using Aspire 3.5.