No Z Zero after reload SB3

[wayne_walker]

I recently had a SB3 just plain stop working so I reloaded it. After putting in the correct values it runs fine. However, now when I do a C2 command it states "No file found (c:....\sbparts\custom\custom90.sbc)" I looked at that file and there is no custom 90. There is a C2 but there is only 2 or 3 lines of text describing what this command does. There are 7 or 8 custom commands in the file but they all read the same except the C99and that appears to be a sample file.

Also, when I hit the space bar to stop the file the pause window looks completely different. The one I had before the reinstall showed the code line so you know where you are at.

This is on old PR that was upgraded to a PRT and I am running V 3.4.8 of SB3. I am not against going to a much newer version, but I have had very few problems with this with the exception of comm problems. The computer I am running is not a dinosaur, more like from the horse and buggy days. Bare bones, no internet hookup...

Thanks in advance for any help you could provide.

Wayne

[Sage Hill]

I just had the same problem. It was working yesterday but today i get the message "file not found C:\sbparts\custom\custom 90.sbc." I tried reloading the software but still get the same message. I'm running a PRT96 with version 3.4.27 software.

Any body have a fix?

[srwtlc]

Did you change/update anything between then and now? Look to see if the file exists. If it doesn't, you can just make or replace it.

File attached if needed. Rename to have just the .sbc extension. Couldn't upload it otherwise.