setting up new PC on the bot, need some settings help!

[Brett1970]

PC in the shop died, finally got a new one together and set up. I need to turn off my limit switches, or they go off no matter where my X and Y are actually at.. thanks! Brett

[scottp55]

VN David,
(ignore Desktop settings in pic)
Maybe somebody else can help you as to WHY they are actually going off?

[jerry_stanek]

PM sent this morn

[bleeth]

When you set up the new software did you select the correct tool? SB went from a normally open switching for proxes to a normally closed system some time ago and if you set up a PRS but have a PRT that could cause that.

[Brett1970]

got a call back from support, all good! I did not know the setting default had changed to normally off. I hadn't actually tried cutting, I just new from previous versions I had to turn it off. As far as why it does it, it's done it since new in 2008, I just turn them off and it's all good. it does not affect automatic zeroing.