x y axis

[Stephen50]

The Shopbot is approximately 3 years old and until recently I've never encountered this situation. I'll type in C3 to set the xy axis the results states xy zeroed. I'll type in FP the correct toolpath appears when the spindle starts it immediately goes left maximum allowance machine limitations. Any suggestions on correcting the problem.

[steve_g]

Stephen…
Can you post the first 50 lines or so of your file?
Thanks!
SG

[Brady Watson]

Sounds like your 0,0 point could have been set in the center of the job in CAD/CAM. Go back and look.

-B

[willmorgan]

Sounds like your 0,0 point could have been set in the center of the job in CAD/CAM. Go back and look.

-B

I agree, I have had that happen before and not pay attention. It also happened when I didn't think to un-check the offset in the CAD/CAM software.

[Stephen50]

Operator error reset 0,0 to lower left corner corrected the problem. Thanks, always nice to find a solution on the forum.