Need speed advice...quick!

[myxpykalix]

lol because i simply can't recall, i need to ask...after i have a 3d finishing toolpath running i want to adjust the Z speed on the fly and just have absolutely forgotten whther i can. If so...how?

[srwtlc]

For the Z speed, Spacebar or Enter to pause and then choose insert command and enter MS or VS when asked. A fill-in sheet will come up and you can enter a new value for the Z speed. After OK on the fill-in sheet, you choose to resume.

WARNING, resume at this point can sometimes be problematic, depending on the version you are running. For just changing speed, it's been fairly safe. You have been warned. No guarantee expressed or implied. ;)

[myxpykalix]

I'm going to just "let it ride"....because just about EVERYTIME i try something like that it winds up screwing up my piece.

[srwtlc]

Probably a good idea Jack. :D