Aspire

[GCoke]

Just Upgraded to Aspire from Vcarve Pro v8. Shopbot cannot find the Aspire toolpaths. Would appreciate any suggestions. Thanks, Gary

[scottp55]

Running the same post processor as VCP?

[t28c34]

Make sure there is no punctuation in the file name

[phil_o]

There are definitely knowledgeable people on this forum, however I would suggest that you post your question on the vectric forum. The people who wrote the software run that one.

Phil

[jerry_stanek]

Where are you saving the files. I make a folder for each job and save them to that folder I do not use the default