Error Message help for beginner

[Violinguy246]

Hi,

I am trying to cut a cello arch that I had designed.

When I start the program I keep getting an error message that reads.

"Parameter value above range for VS---setting to upper limit (253.9999)

I would greatly appreciate any help.

I have been creating the CAM program in Vectric, and Meshcam with the same results.

Thank
John

[Gary Campbell]

You are most likely selecting the wrong unit/time feedrate. for example you may have selected mm/min. You should have selected mm/second

[robtown]

Hi,

I am trying to cut a cello arch that I had designed.

When I start the program I keep getting an error message that reads.

"Parameter value above range for VS---setting to upper limit (253.9999)

I would greatly appreciate any help.

I have been creating the CAM program in Vectric, and Meshcam with the same results.

Thank

John

I believe that's your speed setting. Can you post the first couple lines of your .sbp file?