Spindles won't turn off when cutting is done

[cradke0419]

I have a shopbot alpha 2004 and use vcarve pro. It has two Colombo spindles and when I setup a file to run it will not turn off the spindle when that head is finished. Example- if I use the z head first it will continue to run after it is finished cutting until the a axis fires up. (Which has about a 5-10 second delay before the a axis turns on.)Then z axis turns off and the a axis does it's thing. Then a axis is done cutting and will continue to run. It will also do this using ecabinets.

[Gary Campbell]

Colin...
You will want to look at the "C6" and "C7" custom files to audit the sub routines that they run.

[cradke0419]

I went to the c drive and looked up the custom files but I'm not sure what I am looking at. Anywhere I can look to learn more about this?

[jerry_stanek]

Go to c drive then sbparts you will see custom open that and look at the c6 and c7 files

[cradke0419]

Yeah I was able to pull up the c6 and c7 command but I'm not sure what it is supposed to look like. I would load a picture but I am not sure how to do that