Custom Command

[Austin Shafer]

Hello all,

I know this is probably a dumb question that I should know by now, but how/can you make a custom move command? Like MH moves home but I would love to have a command that moves to the position where we change our bit cause we still do that manually.

Thanks

[Tim Lucas]

Open SB3, go in [C]uts below c9 you should see how to add a custom cut

Tim

[Austin Shafer]

Open SB3, go in [C]uts below c9 you should see how to add a custom cut

Tim

Its so EASY! Thank You! I do not know why I did not do this sooner....

[bill.young]

If you want to z-zero at the same location EVERY time you run it, you can also add that location to the zeroing routine using the ShopBot Setup program, [TS].
30389

[scottp55]

In my Keypad I have #4 radio button always at my normal toolchange position, but usually don't have to do anything as most of my Vectric files have that as my home position so I don't even have move Z for a normal toolchange.
2 cents:)
scott