Change Z settings in C2 Z-Zero command

[phil_o]

At the end of the Z-Zero command (C2) the Z axis is raised by a set value above the workpiece. How can I change the Z value?

Thanks,

Phil

[EricSchimel]

I'm pretty sure it pulls up to the "Safe Z height" which you can set in your SB3 program. Hit "VC" when you're in SB3, that should bring you to the place where the safe Z settings are.

[curtiss]

You can type in VA and ... assign new values to any or all of the three axis

[phil_o]

Thank you gentlemen.

Phil :)

[Martin Reid]

Dear Phil

We change our 'pull up' for certain operations there are two commands we use to change the values. VC (Cutter Values - safe pull up) and TS Shopbot Setup - be careful the dialog 'hides' behind the preview window - [Next] [Next] Safe Z-up [Next] (another setting) [Next] [I'm Done].

It might be that one of these commands overwrites the values in the other, but if it's not broke don't fix it.

Sincerely and in good faith
Martin